Motor
|
Mode: EX1203 KV6200
Configu-ration:9N12P
Stator Diamter:12mm
Stator Length:3mm
Shaft Diameter:Φ1.5mm
Motor Dimension(Dia.*Len):Φ15mm*15mm
Weight(g):4.7g
No.of Cells(Lipo):2S-3S
|
Flight controller
|
(Frsky SPI RX version) CRAZYBEE F4FR PRO V3.0 Firmware target: CrazybeeF4FR
(Flysky SPI RX version) CRAZYBEE F4FS PRO V3.0 Firmware target: CrazybeeF4FS
(External RX version) CRAZYBEE F4 PRO V3.0 Firmware target: CrazybeeF4DX
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Board size: 28.5 * 28.5MM
Power supply: 2-4S battery input (DC 7-17V)
Built-in 10A(each) Blheli_S 4in1 ESC Dshot600 ready
Could add external receiver on the FC board
Built-in Betaflight OSD(SPI Control)
Built-in Current meter Max 70A
Current meter scale set to 470
Built-in 5V 1A BEC
Built-in voltage detection
|
Onboard 4in1 ESC
|
MCU upgraded to EFM8BB21
Power supply: 2-4S LiPo/LiPo HV (7v/17v)
Current: 10A continuous peak 12A (5 seconds)
Support BLHeliSuite programmable
Factory firmware: F_H_40_REV16_7.HEX
Default protocol: DSHOT600
|
Frsky SPI D8 receiver Version
|
SPI BUS receiver Frsky D8 compatible
Compatible Non EU transmitter D8 model
Channels: 8ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
|
Flysky SPI receiver Version
|
SPI BUS receiver
Protocol: AFHDS and AFHDS-2A Switchable
Channels: 8ch(AFHDS) or 14ch(AFHDS-2A)
No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m
Failsafe support
|
External DSMX version
|
Resolution: 1024/2048
Operating voltage: 3.3V
Working current: 60MA
Size: 18mm*13mm*5mm
Antenna length: 30mm
Protocol: DSM2/DSMX
|
External Frsky XM+ version
|
Dimension: 21.5*12*3.5mm(L x W x H)
Weight: 1.6g
Number of Channels: Up to 16CH from SBUS (1-15ch for PWM,16ch RSSI for FC)
Operating Voltage Range: 3.7~10V
Operating Range: Full range
With RSSI output on board: Analog 0~3.3V
Antenna: 10cm
Firmware Upgradeable
Compatibility: FrSky D16 mode
|
External Frsky RXSR version
|
Weight: 1.5g
Number of channels: 16CH (1-16CH from SBUS channel, 1~8CH from CPPM channel)
Operating Voltage Range: 3.5V~10V
Operating Current:70mA@5V
Firmware Upgradable
Compatibility: FrSky X Series modules and radios in D16 mode
Could support Frsky New ACCST Protocol ( Upgrade firmware)
|
External TBS CRSF Nano receiver version
|
Original TBS CROSSFIRE Receiver ,CRSF Protocol , Official TBS transmitter compatible
|
VTX
|
Output power: 25~200mw switchable
Frequency: 40CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)
Antenna: Micro UXII Antenna
Frequency: 5.8GHz 5bands 40 channels
With Race band
Smartaudio ready
Weight: 3g
|
Caddx Baby turtle
|
TV system: NTSC/PAL changeable
Video Resolution: 1080P@60fps / 1080P@30fps / 720@60fps
Power Input: DC 4.5-20V
Mini Illumination: 0.01lux
Image Resolution: 2 Megapixels
Working Current: 380mA@5V/160mA@12V (low consumption)
OSD Menu: Yes (Support Voltage Display)
Video Files: MP4
Audio: Support
Electronic Shutter : PAL : 1/50-100,000 NTSC : 1/60-100,100
S/N Ratio: >60dB (AGC OFF)
Video Output: CVBS
Max Micro SD Card Supported: 8-64GB(need Class 10 or above, recommend Class 10/UHS-I/UHS-II)
|
Lipo Battery
|
Capacity:450mAh
Voltage:11.4v
Continuous Discharge Rate: 75C
Size: 66mmx21mmx18mm
Weight: 42g
Connector: XT30
|