Hobbywing SeaKing Pro V3 160A Waterproof 2-6S Lipo 4A BEC Speed Controller Brushless ESC for RC Racing Boat
Hobbywing SeaKing Pro V3 160A Waterproof 2-6S Lipo 4A BEC Speed Controller Brushless ESC for RC Racing Boat
Hobbywing SeaKing Pro V3 160A Waterproof 2-6S Lipo 4A BEC Speed Controller Brushless ESC for RC Racing Boat

Hobbywing SeaKing Pro V3 160A Waterproof 2-6S Lipo 4A BEC Speed Controller Brushless ESC for RC Racing Boat

Regular price $112.30 Sale price $131.94 Unit price per
Shipping calculated at checkout.

Hobbywing SeaKing Pro V3 160A Waterproof 2-6S Lipo 4A  BEC Speed Controller Brushless ESC for RC Racing Boat

Product Spacifications:

Name : Hobbywing Seaking Pro 160A brushless ESC

Con.Current : 160A

In.Current : 1050A

Battery : 2-6S Lipo / 6-18 cells NiMH

BEC Model : Switch Model

Outtput :6V-7.4V / 4A

Power Lines :  Red--12AWG-200mm x 1 / Black --12AWG-200mm x 1

Output Line : Black --12AWG-150mm x 3

Power Plug : No

Output Plug : No

Parameter setting mode :

(1)Not support remote control ,

(2)support LED programming box Scheduling

(3) Support WiFi Express wireless module

Parameter interface : Throttle cable with yellow lines

Firmware upgrade : Support 

Size : 108.5x51.5x14.4mm

Weight : 127g

Suitable : Mono2 / ≤120cm Length Boat

Connecting the electronic governor
1. Install a water-cooled pipe silicone (silicone water cooling pipes to bring your own):
Electric heat sink faucets containing tone, an outer diameter of 5.5mm, for connecting silicone water cooling pipes. Water and
Tap connection position required tie tied tight.
2. Connect the motor:
ESC and motor is connected to the line no strict timing requirements, the ESC's three output lines with three-wire motor
Casual butt, if there turn in the opposite, exchange any two motor cable.
3. Connect the receiver:
• Connect throttle cable (red black and white tricolor cable):
The ESC throttle control cable into the throttle channel (ie THROTTLE channel) receiver. ESC throttle
Output voltage control line also 6V / 7.4V to the receiver and servos, so do not give the receiver an additional power supply,
Doing so may damage the ESC.
• Connect overspeed trigger signal line (single yellow line):
The ESC overspeed trigger signal line at a free passage into the receiver (such as CH3 / CH4) can be.
4. Connect the battery:
ESC input line there is polarity, insert the battery, make sure the ESC (+) pole of the battery (+) phase
Even, (-) pole and (-) is connected. If the power reverse, the ESC will be damaged.

Share this Product