QWinOut DIY RC Drone Quadrocopter Full Kit X4M380L Frame Kit APM 2.8 GPS AT9 TX Radiolink AT9 Transmitter DIY Drone Parts
Package include:
X4M380L Fiberglass Frame *1
Clockwise Brushless Motor *2
Counter-clockwise Brushless Motor *2
30A Brushless ESC Speed Controller *4
9443 Propeller *2
KK Connection Board *1
APM2.8 Flight Control *1
6M GPS with Compass *1
3.5mm Bullet Connector *12
20cm Hook and & Loop Fastening Tape *1
T Plug Male Connector Silicone Wire *1
5pcs 10cm Servo Receiver Extension Lead Wire Cable*1
GPS Folding Antenna Mount Holder*1
11.1V 3300Mah 25C Lipo Battery *1
Radiolink AT9 Transmitter *1
IMAX RC B3 Pro Compact Balance Charger *1
Before you can configure your APM,
you will need to first connect everything together.
This guide will show you all the cables and parts that you will need to connect to your APM.
Typical Quadcopter Layout
Please note the illustration Below highlights a (TYPICAL) installation. It contains optional equipment including a Camera Gimbal and a Battery Monitor and it utilizes an ESC wired "Y" power connection rather than the power distribution board common to many MultiCopters.